Use STEP extension in LOOP – SAP ABAP [7.40] [english]

Post Content

In today’s video, I will show you an extension that can be used in a loop. Until now, the iteration and the direction in which an internal table is run through was predefined. With the STEP extension, these two properties can be customized.

I have not yet used or needed this extension. At the moment, I can’t think of a use case where something like this might be needed. Do you have any ideas?

#sap #abap #loop #step #stepbystep

If you enjoy my content, fuel my caffeine addiction and buy me a coffee! Your support keeps me awake and the videos rolling! https://bit.ly/3dih2cl Thanks!

▬▬ Linktree ▬▬▬▬▬▬▬▬▬▬▬▬▬▬
https://linktr.ee/CustAndCode

▬▬ Literature ▬▬▬▬▬▬▬▬▬▬▬▬▬
ABAP: An Introduction 2020 https://amzn.to/45CLTqk *
Complete ABAP 2023 https://amzn.to/45D5UNM *
ABAP to the Future 2022 https://amzn.to/42cgWGs *
Clean ABAP 2022 https://amzn.to/3KAqmow *

▬▬ My Hardware ▬▬▬▬▬▬▬▬▬▬▬▬▬
Microphone: https://amzn.to/3zj2UIz *
Headphone: https://amzn.to/3GUBRFg *

▬▬ My Software (free) ▬▬▬▬▬▬▬▬▬▬▬
Video Recorder: https://bit.ly/678fgh6
Video Editor: https://bit.ly/38Rj9lb
Thumbnail: https://bit.ly/CustAndCodeThumbnail
Gamma AI: http://bit.ly/3nsdvgr